Diablo® III

Crossfire enabled, but 1 card idle -- SOLVED

I've got a crossfire enabled setup and just ran 3dMark to verify proper operation. When I play D3, one card goes to the 725 MHz core and heats up to 63C, the other hangs at 157 MHz with a temp down at 38C. The GPU Load on card 1 gets to around 75% and #2 stays at 0. Both cards are ATI 5850s. Any idea why card #2 doesn't get used?

Thanks!
Edited by SilentMike69#1275 on 1/5/2013 5:12 AM PST
Reply Quote
Just a follow up, I got a 217 monster massacre (golf clap) and during this spree my 2nd card finally went up to 725MHz, didn't notice the utilization since I was a little busy.

Is it perhaps that the 2nd card just isn't needed most of the time?
Reply Quote
change your display settings to full screen
Reply Quote
01/04/2013 05:56 AMPosted by iMAGEek
change your display settings to full screen


TYVM -- problem solved.
Reply Quote

Please report any Code of Conduct violations, including:

Threats of violence. We take these seriously and will alert the proper authorities.

Posts containing personal information about other players. This includes physical addresses, e-mail addresses, phone numbers, and inappropriate photos and/or videos.

Harassing or discriminatory language. This will not be tolerated.

Forums Code of Conduct

Report Post # written by

Reason
Explain (256 characters max)
Submit Cancel

Reported!

[Close]